Welcome to tattoo DIY!| Sign In | Register
Home >  Tattoo Wiki >  Tattoo needles >  Tattoo needle installation method

Tattoo needle installation method

RSS Feed
Sunday 29 March, 2015 Written by tattoodiy
Insert the new tattoo needle slowly sterilized handle in the system. Have to be very careful, don't let the needlepoint touching anything, including needle mouth of pipe wall and the edge, and then insert the handle system frame lock in front of the mouth, fingers tighten screw. 
Because to prevent pigment condensation, but also convenient and clean needle mouth, the tip of the needle mouth are generally inclined to speak. This is a available, clean needle mouth. The opening should have been on the front of the machine, rather than the back or side. 
Pay attention to the end of the needle bar is a circle, the circle through a needle tail rubber mat to install it to the end of the armature (the needle tail rubber pad often need to change). 
Carefully observe the needlepoint welding characteristics, you should understand that tip the installation wall under the needle mouth when it should be close to the mouth, this will prevent the tattoo needle in the process of jitter, can also be between pin and wall adsorption of tattoo pigment, ease of work. Correct position of the needle is determined, then we can use 1, 2, moderate elastic rubber band took needle, as far as possible against let needle mouth under the wall, a shaking of the tattoo needles to prevent work. 
The machine is in basically together now. Needle mouth need final correction, that is, changes in the end of the needle mouth exposed outside the length of the needle tip. To press armature which depend on the coil, hold it, mediation needle mouth up and down to let the needle point out the proper length. Let go of the armature, so it can bounce and depend on the top of silk. This clock is not exposed tip of the needle mouth. Determine the needle mouth open place is on the front, and screw down the screws. Now machine is assembled, can start a real tattoo. Check whether the machine is pulling the tattoo needle, needle is doing the right up and down. 
Can only make good tattoo needle strictly moves up and down. Have a clockwise will crazy or moved to one side. Start the machine to check whether there is this kind of situation, if any, should be to solve this problem as soon as possible, so as to ensure the stable smooth lines when the tattoo. 
Sometimes slightly reduced voltage is also can have the effect, but also should check whether the tip is damaged. But needles along the top of the needle bar to add one or more rubber band from different directions, until you reach a certain amount of tension, so as to prevent the shaking of the needle. Don't bend needle stick, with high power magnifying glass eye detection when the machine is suitable to turn to ensure that the needle just do up and down. To avoid any jitter. Each needle should be clear, not vague. When you use a magnifying glass to test the correct of the needle eye movement, is time to check whether the tip is damaged (see section) on the needle. This should be a habitual action, because the whole process of inspection should be in tattoo secant and play before the fog. If you use a needle has been shaking machine tattoo, so the needle skin cut will be quite serious, even tear the skin, can also cause pigment is hard to Pierce the skin, the skin began to heal the difficult delusion, resulting in destruction color. Because of this, we adjust the tattoo needles this whole operation is just a few minutes, well done also can save a lot of time, and avoid when tattoo injection color and start to recover the wound callus. 
 
Newsletter: for the latest offers, discount and site activity! Your email address: