Welcome to tattoo DIY!| Sign In | Register
Home >  Tattoo Wiki >  Tattoo machines >  Seven key steps to debug the tattoo machine

Seven key steps to debug the tattoo machine

RSS Feed
Saturday 03 May, 2014 Written by tattoodiy

The first step
the tattoo machine needles with his left hand  with index finger to resist "host" bottom
Department  the thumbs down
"Needle fixed button" location.
The second step
connect ac power jack cable access tattoo machine.
The third step
in the right hand thumb and forefinger "adjust the fixed button" to "relax" state.
The fourth step
in the right hand thumb and forefinger "pressure regulating knob"  to adjust the pressure regulating knob at the same time
Right foot pedal switch " start tattoo machine.
Step 5
the right hand thumb and forefinger
"Pressure regulating knob"
pay attention to the right hand has been to leave or put
loose
"Pressure regulating knob"
until tattoo machine to produce the best speed and sound.
At the same time with the left hand thumb belly touch the magnetic force
The front end of the article  needle bar fixed button below. In the left hand thumb tactility is maximum vibration  to feel numb
Wood, itch so far   tattoo machine is the best working state at this time.
Step 6
in the debug tattoo machine  tattoo machine should pay attention to our trip   trip for tattoo machine
The magnetic force and magnetic coil  this trip must ensure that at least for the spacing
The 2.5 MM
. Because this is confirmed
Have enough telescopic distance to ensure that the needle can Pierce the skin when stretched out the underlying  while retracting can retreat into again
Stick to a pigment in the needle.
Step 7
To the best state   tattoo machine left right foot "foot switch"
lines - breaking power
Machine body is in a state of downtime  in the right hand thumb
Fixed button "adjustment" means and the index finger to adjust to the tight state  the lock
Set"
Press button"
.

 

Newsletter: for the latest offers, discount and site activity! Your email address: