Welcome to tattoo DIY!| Sign In | Register
Home >  Tattoo Wiki >  Tattoo machines >  Debugging of tattoo machine

Debugging of tattoo machine

RSS Feed
Tuesday 14 October, 2014 Written by tattoodiy
The machine always wanted to share their knowledge and experience with you, but always felt they were still groping, we could not be documented. Recently in-depth understanding of the machine after the erudite, write it down with you to discuss, but this is only my feelings right now, I have been changed, I will also become, just wanted to write to you for reference and reference. Again the power is not fixed, I hope I can help you in these words. 
A tattoo machine to get his hand, allowing us to adjust only the following aspects: location before shrapnel, after shrapnel, after spacing, contact screws, damping rings, coils, rubber bands, armature. The coil, core, racks, capacitors basically we are not moving. All adjustments are around two factors - the frequency and strength, I will be one of the law in the following eleven come. 
 
Before shrapnel: length width thickness and hardness bending angle will affect the frequency and power of the machine. Long, narrow, thin, soft, bend angle low frequencies will make the machine slows down, the power becomes larger. Conversely frequency becomes fast, the strength becomes smaller. 
 
Damping ring: the thickness of hard and soft, thin, soft make frequency slows down, the power becomes larger. Vice versa. In fact, is an extension of the front damping ring shrapnel, shrapnel can even do a good pre-damping ring, as before shrapnel power play to the maximum, maximum strength. 
 
The contact screw: nearer the position of the contact point of the front tip of shrapnel, the slower the frequency, the greater the force, and vice versa. Contact force is smaller and more tightly screw presses, frequency faster. Recommend contact screws as far forward, touch the shrapnel, at most, one or two laps and then the next spin, so shrapnel maximize its power. 
 
After shrapnel: width hardness and bending angle will affect the machine's frequency, strength and length of the needle. Narrow, thin, soft frequency will allow the machine slows down, the power becomes larger. Conversely frequency becomes fast, the strength becomes smaller. The larger the longer the bending angle needle, the greater the power of the machine, the slower the frequency, and vice versa. 
 
After the pitch: refers to the distance between the machine back seat and armature, in fact, this distance is, after changing the length of shrapnel that can be achieved through several ways to adjust the length of the armature, the size of the shrapnel platen, after shrapnel forward, these three who can change the spacing. The larger the greater the power of the pitch, the slower the frequency, and vice versa. 
 
Positions of the coils: coil former (close to the needle that the coil) the greater the strength of the front, the greater the power the greater the distance between the front and rear coils. As far forward before the proposal coil after coil do not move. 
 
Armature: armature material, the length of the severity of the armature is longer, the more severe the greater the force, the slower the frequency. I only know the material aspects of being better off magnetic armature better. 
 
Rubber band: as little as possible to use, as long as you can control the beating of the needle, the correct way to reduce needle loaded needle beating, so only twelve rubber band can be. 
 
Under normal circumstances thorn color, totem need big machine power, frequency, slow, black and white sketch thorn traditional and machine power needs of small, fast frequency. We can adjust to suit your machine according to the above rule.
Newsletter: for the latest offers, discount and site activity! Your email address: