Welcome to tattoo DIY!| Sign In | Register
Home >  Tattoo Wiki >  Tattoo machines >  Correct understanding and using three points of the tattoo machi

Correct understanding and using three points of the tattoo machi

RSS Feed
Wednesday 13 May, 2015 Written by tattoodiy
Judge of the tattoo machine
1. The subject support and all screw details.. Appearance is not beautiful or not, but whether small detail place is neat, a good machine will have a very strong unequivocal support. 
2. The electromagnetic coil and the stability of the shrapnel bounce, simple look not promptly contact with spark phenomenon, or use for a period of time will have overheating occurs. 
3. Listen to the voice is the most simple way to determine machine, sometimes good machine bounce up there will be a very solid sound, there will not be spread. 
Tattoo machine is very important for the artist, like the sword is the life of the swordsman, tattoo machine is the life of the tattoo artist, good quality machine to let you get twice the result with half the effort, with ease, inferior machine will not only damage to the guest's skin, and will seriously affect their confidence in tattoo on the road. 
Tattoo machine commissioning procedures 
The first step: the tattoo machine needles with his left hand, with the index finger to resist the bottom of the "host", thumbs down "the needle fixed new" location. 
Step 2: connect the ac power, the connector jack access tattoo machine. 
Step 3: with the right hand thumb and forefinger "adjust the fixed button" to "relax" state. 
Step 4: with the right hand thumb and forefinger pressure regulating knob, adjust the pressure regulating knob at the same time, with his right foot stepping on the pedal switch, start the tattoo machine. 
Step 5: the right hand thumb and forefinger to adjust the pressure regulating knob, pay attention to the right hand always cannot leave or relax the pressure regulating knob, until the tattoo machine to produce the best speed and sound. At the same time to touch the magnetic force of the left thumb belly front-end, needle bar fixed button below. Thumb with his left hand touch is the largest vibration numbness, itching (to) at this point, the tattoo machine is the best working condition. 
Step 6: in the debug tattoo machine, tattoo machine, should pay attention to our article (trip to tattoo machine magnetic and magnetic coil spacing) this trip must ensure that a minimum of 2.5 MM. Because in this way can we ensure the needle enough scale distance, to ensure that the needle can Pierce the skin layer when stretched out, and back again to shrink into the needle stick to pigment. 
Step 7: tattoo machine to the best state, the right to leave the "foot switch" - breaking power, tattoo machine in stop state, the right hand thumb Fixed button "adjustment" means and the index finger to adjust to the tight state, locking "press button". 
After completing the above seven steps, restart the tattoo machine, commissioning! Work best! Tattoo machine debugging is completed. 
Use the tattoo machine 
Attention tattoo machine needles do not touching the skin outside of any object, the potion, the needle must stop fibrillation, prevent the liquid medicine box, such as needlepoint bending will not be able to work, can use a sandpaper in needle direction to gently, and then, with a thick cocoon skin test needle, not hook the skin as well. 
Tattoo machine after each use, to prevent dirt, wipe the contact needle, needle disinfection, fuselage rub-up, the fuselage and two pieces of magnetic point to prevent rust. Such as contact point contact undesirable, light can use paper to wipe, or can use sand paper burnish adjustment screw. Use for a long time contact to fold down to mass, hands folded up when available. This is a very good maintenance of the tattoo machine details. 
 
Newsletter: for the latest offers, discount and site activity! Your email address: